LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 646 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Hood Hinge Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Hood Hinge To Hood Bolt
    GM867790Courtesy of GENERAL MOTORS CORP.
  1. Position the hood hinge to the alignment marks on the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the hood hinge to body bolts.

    Tighten:  Tighten the hood hinge to body bolts to 10 N.m (89 lb in).

  3. Install the front fender. Refer to Front Fender Replacement .
  4. Remove the hood to air inlet grille panel support.
  5. Slowly lower the hood.
  6. Inspect the hood alignment. Align the hood if necessary. Refer to Hood Adjustment .
  7. Tighten the hinge to hood bolts.

    Tighten:  Tighten the hinge to hood bolts to 10 N.m (89 lb in).

  8. Close the hood.
scientia non olet · About LEMON Manuals