Door Lock Striker Adjustment
WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- Loosen the striker bolts (2).
- Attach the striker bolts (2) snugly in order to ensure that the striker (1) is still movable.
- Pull on the outside handle.
- Gently push the door against the body in order to ensure that the striker (1) allows a flush fit.
- Slowly open the door.
- Tighten the bolts (2).
Tighten: Tighten the striker bolts (2) to 25 N.m (18 lb ft).
- Touch up any exposed or unpainted surface on the lock pillar.
NOTE:
Striker alignment is a crucial part of door latch operation. Do not use the door striker to adjust the door to the vehicle. Failure to properly adjust the striker can result in damage to the door latch and the striker.
NOTE:
Refer to Fastener Notice
.