Component Testing
WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
Rear Compartment Lid Release Actuator
- Ignition OFF, disconnect the harness connector at the Rear Compartment Lid Release Actuator.
- Install a 20-amp fused jumper wire between the control circuit terminal 4 and 12 volts. Install a jumper wire between the ground circuit terminal 3 and ground. Verify the rear compartment lid release actuator activates.
- If the actuator does not perform as specified, replace the rear compartment lid release actuator.