LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 643 (Fixed & MOVEABLE Window Systems) >> Repair Instructions >> Windshield Reveal Molding Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: The window reveal molding is an applied molding design that is separate from the window. The reveal molding may be replaced with the window as an assembly, or the reveal molding may be available as a separate part. The window molding can only be replaced by removing the window. The old molding can not be reused.
    Fig 1: Removing Windshield
    GM1215274Courtesy of GENERAL MOTORS CORP.
  1. Remove the windshield. Refer to Windshield Replacement .
  2. Place the window on a clean prepared surface.
  3. Remove the molding from the windshield using a razor scraper.
scientia non olet · About LEMON Manuals