Installation Procedure
WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- Install the lower steering column cover.
- Install the lower steering column cover screws.
Tighten: Tighten the lower steering column cover screws to 2 N.m (17 lb in).
- Install the upper steering column trim cover by guiding the soft closeout under the I/P Trim Panel.
- Push on the upper steering column cover until it snaps into place and is secure.
- Enable the SIR system. Refer to SIR Disabling and Enabling .
NOTE:
Refer to Fastener Notice
.
IMPORTANT:
Tighten the lower steering column screws in the mandatory torque sequence as shown.