Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Failure to transfer the pre-scribed marks may result in an off-center steering wheel.

If installing a new intermediate shaft, transfer the pre-scribed alignment marks onto the new part.

Fig 1: View Of Intermediate Steering Shaft Assembly

Courtesy of GENERAL MOTORS CORP.

Install the intermediate shaft/seal through the front of dash.

IMPORTANT: To ensure seal is properly seated, inspect the seal from the engine side of the seal.

Seat the intermediate shaft seal using a pushing, squeezing and twisting motion until seal is fully seated.
Align the pre-scribed mark on the intermediate shaft to the pre-scribed mark on the steering column shaft.
Connect the intermediate shaft to the steering column shaft.

Fig 2: View Of Upper Intermediate Shaft Pinch Bolt And Column

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install a new intermediate shaft to steering column pinch bolt.
Tighten: Tighten the bolt to 34 N.m (25 lb ft).
Connect the intermediate shaft to the steering gear.

Fig 3: View Of Intermediate Shaft-To-Steering Gear Pinch Bolt

Courtesy of GENERAL MOTORS CORP.

Install a new intermediate shaft to steering gear pinch bolt.
Tighten: Tighten the bolt to 34 N.m (25 lb ft).
Install the left front wheel. Refer to Tire and Wheel Removal and Installation (4 Lug Wheel) or Tire and Wheel Removal and Installation (5 Lug Wheel) .