LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 641 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Compressor Clutch Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the compressor. Refer to Compressor Replacement (RPO LSJ)  or Compressor Replacement (RPOs L61, LE5) .
    2. Fig 1: Identifying Compressor Clutch Plate Bolt
    GM872553Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Remove the three adjustable dowels from the J 37872  Universal Spanner Wrench.
    Install three 5/16 x 1 inch bolts in place of the dowels.
  2. Remove and discard the compressor clutch plate bolt.

    Use the J 37872  to hold the compressor clutch plate from turning.

    3. Fig 2: Identifying Compressor Clutch Plate
    GM872556Courtesy of GENERAL MOTORS CORP.
  3. Remove the compressor clutch plate from the compressor.
    4. Fig 3: View Of Compressor Pulley Snap Ring
    GM872558Courtesy of GENERAL MOTORS CORP.
  4. Remove the compressor pulley snap ring using the J 6083  .
    5. Fig 4: Identifying Compressor Pulley
    GM872560Courtesy of GENERAL MOTORS CORP.
  5. Remove the compressor pulley from the compressor.
    6. Fig 5: Identifying Compressor Clutch Coil And Snap Ring
    GM872563Courtesy of GENERAL MOTORS CORP.
  6. Remove the compressor clutch coil snap ring using the J 6083  .
    7. Fig 6: Identifying Compressor Clutch Coil To Compressor
    GM872561Courtesy of GENERAL MOTORS CORP.
  7. Remove the compressor clutch coil from the compressor.
scientia non olet · About LEMON Manuals