LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 641 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Blower Motor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Blower Motor Electrical Connector
    GM1543403Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the blower motor electrical connector.
    2. Fig 2: View of lower blower motor cover heat stakes
    GM1732377Courtesy of GENERAL MOTORS CORP.
  2. Remove the lower blower motor cover heat stakes (1) with a small chisel.
    3. Fig 3: View of lower blower motor cover
    GM1725760Courtesy of GENERAL MOTORS CORP.
  3. Remove the lower blower motor cover.
  4. Remove the blower motor nuts.
    5. Fig 4: Identifying Blower Motor Nuts
    GM1543423Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Cut through the case as straight as possible because the motor cup must be replaced. In order to prevent damage to the component, do not cut any deeper than necessary to remove the motor cup.
    Fig 5: Cutting Through Case
    GM1543470Courtesy of GENERAL MOTORS CORP.
  5. Remove the blower motor and cup from the lower case by cutting through the case between the circular ribs around the motor with a sharp utility knife.
  6. Release the blower motor retaining tab using a screwdriver and remove the motor from the cup.
    7. Fig 6: Releasing Blower Motor Retaining Tab
    GM877664Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals