Seat Belt Retractor Pretensioner Replacement - Front
WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
Seat Belt Retractor Pretensioner Replacement - Front
| Callout | Component Name |
|---|---|
| Preliminary Procedures: Disable the SIR in Zones 2 or 6. Refer to SIR Disabling and Enabling . |
|
| 1 | Seat Belt Anchor Bolt
NOTE:
Refer to Fastener Notice
. Tip: Move the seat to the full forward position to gain access to the bolt. Tighten: 45 N.m (33 lb ft) |
| 2 | Seat Belt Adjuster Cover |
| 3 | Seat Belt Adjuster Bolt Tighten: 45 N.m (33 lb ft) |
| 4 | Seat Belt Retractor Bolt Tip: Remove the center pillar lower trim panel to gain access to the bolt. Refer to Center Pillar Lower Garnish Molding Replacement . Tighten: 45 N.m (33 lb ft) |
| 5 | Front Seat Belt Retractor Assembly Tip: Disconnect the belt tension sensor electrical connector. |