Windshield Garnish Molding Replacement

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Replacing Windshield Garnish Molding

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .
1	Trim Cover, Screw Panel Assembly Front Pillar
2	Screw, Panel Assembly Front Pillar Tighten: 2 N.m (18 lb in)
3	Panel Assembly, Front Pillar Tip: Disconnect the boost gauge connector if equipped.
4	Clip, Panel Assembly Front Pillar