Troubleshooting with a Digital Multimeter

NOTE: Refer to TEST PROBE NOTICE in Cautions and Notices.

IMPORTANT: Circuits which include any solid state control modules, such as the PCM, should only be tested with a 10 megohm or higher impedance digital multimeter such as the J 39200 . See Special Tools .

The J 39200 instruction manual is a good source of information and should be read thoroughly upon receipt of the DMM as well as kept on hand for future reference. See Special Tools .

A DMM should be used instead of a test lamp in order to test for voltage in high impedance circuits. While a test lamp shows whether voltage is present, a DMM indicates how much voltage is present.

The ohmmeter function on a DMM shows how much resistance exists between 2 points along a circuit. Low resistance in a circuit means good continuity.

IMPORTANT: Disconnect the power feed from the suspect circuit when measuring resistance with a DMM. This prevents incorrect readings. DMMs apply such a small voltage to measure resistance that the presence of voltages can upset a resistance reading.

Diodes and solid state components in a circuit can cause a DMM to display a false reading. To find out if a component is affecting a measurement take a reading once, then reverse the leads and take a second reading. If the readings differ the solid state component is affecting the measurement.

Following are examples of the various methods of connecting the DMM to circuit to be tested:

Backprobe both ends of the connector and either hold the leads in place while manipulating the connector or tape the leads to harness for continuous monitoring while you perform other operations or test driving. Refer to Probing Electrical Connectors .
Disconnect the harness at both ends of the suspected circuit where it connects either to a component or to other harnesses.
If the system that is being diagnosed has a specified pinout or breakout box, it may be used in order to simplify connecting the DMM to circuit or for testing multiple circuits quickly.