Headlamp Capsule, Headlamp Housing Bracket, Fog Lamp Replacement

Fig 1: Headlamp Capsule, Headlamp Housing Bracket, Fog Lamp Replacement

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .
Headlamp Capsule Replacement
1	Bolt, Front Headlamp Capsule (Qty: 2) Tip: Remove the inner upper grille fascia push-pin. Pull the lamp forward until the lamp disengages from the lower bracket. Push the lower inside corner of the headlamp inboard until the outer lens releases from under the outer fender flange. Rock the headlamp composite side to side and pull outward. Disconnect the electrical connector. Tighten: 10 N.m (89 lb in)
2	Bulbs, Headlamp CAUTION: Refer to Halogen Bulb Caution . Tip: Rotate the bulb/socket counterclockwise to remove from the capsule.
Headlamp Housing Bracket Replacement
3	Bolt, Headlamp Housing Bracket (Qty: 4) Tighten: 10 N.m (89 lb in)
4	Bracket, Headlamp housing
Fog Lamp Replacement
5	Bulb/Socket, Fog Lamp Tip: Disconnect the electrical. Rotate the bulb/socket counterclockwise to remove from the fog lamp. The fog lamp bulb/socket can be replaced, without removing the fog lamp.
6	Lamp, Fog Tip: Disconnect the electrical connector from the fog lamp bulb/socket. Release the fog lamp from the front fascia.