Daytime Running Lamp, Park and Turn Signal Lamp and Bulb Replacement - Front

Fig 1: Exploded View Of Daytime Running Lamp, Park and Turn Signal Lamp

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice in Cautions and Notices. Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .
DRL, Park, and Turn Signal Lamp Replacement
1	Pin, Headlamp Mounting Panel
2	Bolt, Headlamp Mounting Panel Tighten: 12 N.m (106 lb in)
3	Headlamp Assembly Tip: Pull the headlamp forward to disengage the ball and socket attachment at the rear of the headlamp. Disconnect the electrical connector.
4	Nut, Daytime Running Lamp (Qty: 3) Tighten: 6 N.m (53 lb in)
5	Lamp Assembly, Daytime Running, Park, and Turn Signal Disconnect the electrical connector. Slide the lamp forward to remove from the fascia.