LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 4.8L, 5.3L & 6.0L (Repair Instructions - 1 Of 3) >> Repair Instructions (On-Vehicle And Off-Vehicle - Part 1) >> On-Vehicle Repair Instructions >> Drive Belt Replacement - Air Conditioning >> Removal Procedure

Removal Procedure

    Fig 1: View Of Engine Protection Shield
    GM349061Courtesy of GENERAL MOTORS CORP.
  1. Remove the accessory drive belt. Refer to Drive Belt Replacement - Accessory (4.8L, 5.3L & 6.0L Engines)  or Drive Belt Replacement - Accessory (5.3L Engine w/RPO HP2) .
  2. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Remove the engine shield bolts.
  4. Remove the engine shield.
    5. Fig 2: A/C Belt Tensioner
    GM370869Courtesy of GENERAL MOTORS CORP.
  5. Install a ratchet into the air conditioning (A/C) belt tensioner adapter opening.
  6. Rotate the A/C belt tensioner clockwise in order to relieve tension on the belt.
  7. Remove the A/C belt from the pulleys.
  8. Slowly release the tension on the A/C belt tensioner.
  9. Remove the ratchet from the A/C belt tensioner.
  10. Clean and inspect the belt surfaces of all the pulleys.
scientia non olet · About LEMON Manuals