LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Optra5 LS, Standard >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Differentials & Drive Axles >> Front Drive Axle >> Repair Instructions >> Wheel Drive Shaft Outer Joint and Seal Replacement (Manual) >> Removal Procedure

Removal Procedure

    Fig 1: Removing/Installing The Outer Joint And The Axle Shaft Snap Ring
    GM1242026Courtesy of GENERAL MOTORS CORP.
  1. Remove the drive axle from the vehicle. Refer to Inner Axle Shaft Replacement - Front Drive Axle (Manual) .
  2. Remove the large seal retaining clamp. Discard the clamp.
  3. Remove the small seal retaining clamp. Discard the clamp.
  4. Degrease the joint.
    5. CAUTION: The outer joint is designed to be replaced as a one piece unit. Do not attempt to disassemble or service the outer joint. Improper service will affect both performance of the vehicle and could cause personal injury or vehicle damage.
  5. Spread the snap ring using the J 8059  and remove the outer joint from the axle shaft. See Special Tools .
  6. Remove the seal from the joint assembly.
scientia non olet · About LEMON Manuals