High Beams Inoperative

Step	Action	Values	Yes	No
1	Inspect the high-beam headlamps in the flash-to-pass mode. Do the high-beam headlamps work in the flash-to-pass mode?	-	Go to Step 10	Go to Step 2
2	Measure the voltage at the headlamp switch connector terminal 7. Does the voltage measure within the specified range?	11-14 V	Go to Step 4	Go to Step 3
3	Repair the open circuit between the headlamp switch connector terminal 7 and the fuse Ef12. Did you complete the repair?	-	System OK	Go to Step 4
4	Inspect fuses Ef15. Is the fuse open?	-	Go to Step 5	Go to Step 6
5	Inspect for a short circuit. Repair it, if necessary. Replace the fuse. Did you find and correct the condition?	-	System OK	-
6	Turn the high-beam headlamps ON. Measure the voltage at fuses Ef15. Does the voltage available at fuses Ef15 measure within the specified range?	11-14 V	Go to Step 7	Go to Step 12
7	Turn the high-beam headlamps ON. Measure the voltage at headlamp terminal 4 (terminal 2 if hatchback) with high beams selected. Does the voltage available at the headlamp connector terminal 4 measure within the specified range?	11-14 V	Go to Step 9	Go to Step 8
8	Repair the open circuit between fuse EF16 and the high-beam headlamps. Did you complete the repair?	-	System OK	-
9	Replace the faulty headlamps. Did you complete the replacement?	-	System OK	-
10	Disconnect the headlamp combination switch connector. Put the switch in the high-beam position. Use an ohmmeter to check the continuity of the headlamp switch between terminals 7 and 4 (terminal 2 if hatchback). Does the ohmmeter indicate the specified value?	0 Ω	Go to Step 12	Go to Step 11
11	Replace the headlamp combination switch. Did you complete the replacement?	-	System OK	-
12	Repair the open circuit between headlamp combination switch connector, terminal 4 (terminal 2 if hatchback), and Ef15. Did you complete the repair?	-	System OK	-