Security Indicator Inoperative
SECURITY Indicator Inoperative
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Theft Deterrent System Schematics Connector End View Reference: Theft Deterrent System Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 |
|
Go to Testing for Electrical Intermittents andTesting for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 | Inspect for poor connections at the instrument panel cluster (IPC). Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 5 | Go to Step 4 |
| 4 | Replace the IPC. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 5 | - |
| 5 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |