Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0117, P0118, P0120, P0121, P0201, P0202, P0203, P0204, P0442, P0443, P0446, P0449, P0452, P0453, P0455, P0496, P1516, P2101, P2135, or P2176 are not set.
The ECT Sensor parameter is more than 70°C (158°F).
The Engine Speed parameter is between 1,500-3,500 RPM.
The Ignition 1 Signal parameter is between 11-18 volts.
The Engine Run Time is more than 3.5 minutes.
The Loop Status parameter is closed.
The TP Indicated Angle parameter is more than 5 percent.
The Fuel Level Sensor parameter is more than 10 percent.
The MAP Sensor parameter is more than 30 kPa.
The MAF Sensor parameter is between 20-50 g/s.
DTC P1133 runs once per drive cycle when the above conditions are met for 2 seconds.