Conditions for Clearing the DTC
WARNING: This page is about a different variant/trim than selected.
- A current DTC Last Test Failed clears when the diagnostic runs and passes.
- A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other non-emission related diagnostic.
- Clear the DTC with a scan tool.
DTC P1112
| Step | Action | Values | Yes | No |
|---|---|---|---|---|
| Schematic Reference: Engine Controls Schematics Connector End View Reference: Engine Controls Connector End Views or Powertrain Control Module (PCM) Connector End Views |
||||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | - | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 | Observe the intake air temperature (IAT) sensor parameter with a scan tool. Is the IAT sensor parameter more than the specified value? |
149°C (300°F) | Go to Step 4 | Go to Step 3 |
| 3 |
|
- | Go to Step 4 | Go to Inducing Intermittent Fault Conditions in Wiring Systems and Intermittent Conditions |
| 4 |
|
-39°C (-38°F) | Go to Step 6 | Go to Step 5 |
| 5 | Test the signal circuit of the IAT sensor for an intermittent short to ground or an intermittent short to the IAT low reference circuit. Refer to Circuit Testing
, Inducing Intermittent Fault Conditions
, and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 10 | Go to Step 7 |
| 6 | Test for an intermittent and for a poor connection at the IAT sensor. Refer to Testing for Intermittent Conditions and Poor Connections
, Inducing Intermittent Fault Conditions
, and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 10 | Go to Step 8 |
| 7 | Test for an intermittent and for a poor connection at the powertrain control module (PCM). Refer to Testing for Intermittent Conditions and Poor Connections
, Inducing Intermittent Fault Conditions
, and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 10 | Go to Step 9 |
| 8 | Replace the MAF/IAT sensor. Refer to Mass Air Flow (MAF) Sensor Replacement
. Did you complete the replacement? |
- | Go to Step 10 | - |
| 9 | Replace the PCM. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? |
- | Go to Step 10 | - |
| 10 |
|
- | Go to Step 2 | Go to Step 11 |
| 11 | Observe the Capture Info with a scan tool. Are there any DTCs that have not been diagnosed? |
- | Go to Diagnostic Trouble Code (DTC) List - Vehicle in Vehicle DTC Information | System OK |