Diagnostic Aids
WARNING: This page is about a different variant/trim than selected.
- An intermittent fault in the crankshaft position (CKP) circuits may cause the PCM to resync the cam and may set this DTC.
- An intermittent short to voltage on the camshaft position signal can set this DTC. A direct short to voltage on the camshaft position signal circuit will set DTC P0340, as there will be no change in the camshaft position signal input.
- Electromagnetic interference (EMI) may also set DTC P0341. Inspect the wiring harness for the following:
- Damage
- Being routed too close to motors, solenoids, and relays
- Being routed too close to secondary ignition wires or components
- Being routed too close to aftermarket add-on electrical equipment
If this DTC is determined to be intermittent, refer to Intermittent Conditions .