Diagnostic Aids

WARNING: This page is about a different variant/trim than selected.

The following conditions may cause this DTC to set:
- Low resistance in both the #1 and #3 secondary ignition circuits
- High resistance in both the #4 and #2 secondary ignition circuits
- An intermittent Crank Signal
An Intermittent crank signal will result in an interrupted cam signal and may set this DTC.
To locate an intermittent problem, use the scan tool to monitor CMP Active Counter parameter while running the engine. The counter should continuously count up to 255, then reset to zero. The counter will stop counting if a fault occurs in the cam signal circuit.
If this DTC is determined to be intermittent, refer to Intermittent Conditions .