Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0117, P0118, P0120, P0121, P0201, P0202, P0203, P0204, P0442, P0443, P0446, P0449, P0452, P0453, P0455, P0496, P1516, P2101, P2135, or P2176 are not set.
The ECT Sensor parameter is more than 70°C (158°F).
The Ignition 1 Signal parameter is between 11-18 volts.
The Fuel Level Sensor parameter is more than 10 percent.
The Engine Run Time parameter is more than 200 seconds.
The Engine Speed parameter is between 1,500-3,500 RPM.
The MAP Sensor parameter is more than 30 kPa.
The MAF Sensor parameter is between 20-50 g/s.
The Loop Status parameter is closed.
The TP Indicated Angle parameter is more than 5 percent.
DTC P0133 runs once per drive cycle, once the above conditions are met for 2 seconds.