Conditions for Running the DTC

Rich Test Enable

• DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0117, P0118, P0120, P0121, P0201, P0202, P0203, P0204, P0442, P0443, P0446, P0449, P0452, P0453, P0455, P0496, P1516, P2101, P2135, P2176 are not set.
• The Loop Status parameter is closed.
• The Ignition 1 Signal parameter is between 11-18 volts.
• The Fuel Level Sensor parameter is more than 10 percent.
• The Throttle Position (TP) Sensor parameter is between 0-50 percent.
• DTC P0132 runs continuously when the above conditions are met for 2 seconds.

Decel Fuel Cutoff Test Enable

• DTCs P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0121, P0122, P0123, P0200, P0300, P0442, P0446, P0452, P0453, P0455, P0496 are not set.
• The Loop Status parameter is closed.
• The Ignition 1 Signal parameter is between 11-18 volts.
• The Fuel Level Sensor parameter is more than 10 percent.
• The Engine Run Time parameter is more than 200 seconds.
• DTC P0132 runs during each occurrence of the Decel. Fuel Cutoff when the above conditions are met for 2 seconds.