Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
- DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0117, P0118, P0120, P0121, P0125, P0131, P0132, P0133, P0134, P0135, P0201, P0202, P0203, P0204, P0220, P1133, P1516, P2101, P2135, P2176 are not set.
- The Engine Run Time is more than 3.5 minutes.
- The Engine Speed parameter is between 1,000-3,400 RPM.
- The Ignition 1 Signal parameter is between 11-18 volts.
- The MAF Sensor parameter is between 10-50 g/s.
- The ECT Sensor parameter is more than 70°C (158°F).
- DTC P0130 runs continuously, once the above conditions are met for 2 seconds.