Test Description
WARNING: This page is about a different variant/trim than selected.
The number below refers to the step number on the diagnostic table.
- 2: This step determines if the condition is with the MIL control circuit or the PCM.
Malfunction Indicator Lamp (MIL) Always On
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Engine Controls Schematics Connector End View Reference: Powertrain Control Module (PCM) Connector End Views or Engine Controls Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 |
|
Go to Step 3 | Go to Step 5 |
| 3 | Test the MIL control circuit for a short to ground. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 6 | Go to Step 4 |
| 4 | Replace the instrument panel cluster (IPC). Refer to Instrument Panel (I/P) Assembly Replacement
in Instrument Panel, Gages and Console. Did you complete the replacement? |
Go to Step 6 | - |
| 5 | Replace the PCM. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the repair? |
Go to Step 6 | - |
| 6 |
|
System OK | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |