Conditions for Running
WARNING: This page is about a different variant/trim than selected.
- DTCs P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0125, P0128, P0130, P0131, P0132, P0133, P0134, P0135, P0136, P0137, P0138, P0140, P0141, P0150, P0151, P0152, P0153, P0154, P0156, P0157, P0158, P0160, P0220, P0443, P0449, P0452, P0453, P0502, P0503, P0562, P0563, P0722, P1106, P1107, P1111, P1112, P1114, P1115, P1133, P1134, P1153, P1154, P1681, P2135, P2610 are not set.
- At least 17 hours have elapsed since the last drive cycle met the Conditions for Running.
- The difference between the startup ECT and the startup IAT is less than 8°C (14.4°F).
- The barometric pressure (BARO) is more than 74 kPa.
- The startup engine coolant temperature (ECT) is between 4-30°C (39-86°F).
- The startup intake air temperature (IAT) is between 4-30°C (39-86°F).
- The fuel level is between 15-85 percent.
- The battery voltage is between 10-18 volts.
- The fuel level does not increase more than 9 percent during this drive cycle.
- The engine run time is at least 10 minutes.
- The vehicle has been driven at least 5 km (3.15 miles) this drive cycle.
- The estimated ambient temperature at the end of this drive cycle is between 2-32°C (36-89°F).
- The shutdown engine coolant temperature (ECT) is at least 70°C (158°F).
- The ignition is turned OFF for at least 1 hour after this drive cycle.