LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu Maxx >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Valve Stem Oil Seal and Valve Spring Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the camshaft. Refer to Intake Camshaft and Lifter Replacement  or Exhaust Camshaft and Lifter Replacement .
    2. Fig 1: Identifying Camshaft Roller Followers
    GM758358Courtesy of GENERAL MOTORS CORP.
  2. Remove the camshaft roller followers.
    3. Fig 2: View Of Valve Spring Compressor
    GM758361Courtesy of GENERAL MOTORS CORP.
  3. Install the J 43649  to the cylinder head. See Special Tools .
  4. Remove the spark plugs. Refer to Spark Plug Replacement in Engine Controls - 2.2L (L61).
    5. Fig 3: View Of Air Hose Adaptor
    GM758363Courtesy of GENERAL MOTORS CORP.
  5. Install an air hose adaptor into the spark plug hole.
  6. Pressurize the cylinder to 690 kPa (100 psi).
  7. Compress the valve spring.
  8. Remove the valve spring keepers.
  9. Remove the valve spring.
    10. Fig 4: View Of J 36017 & Valve Seal
    GM758364Courtesy of GENERAL MOTORS CORP.
  10. Using the J 36017  remove the valve seal. See Special Tools .
scientia non olet · About LEMON Manuals