LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu Maxx >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Valve Stem Oil Seal and Valve Spring Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of J 36017 & Valve Seal
    GM758364Courtesy of GENERAL MOTORS CORP.
  1. Using the J 36017  install the valve seal. See Special Tools .
    2. Fig 2: View Of Air Hose Adaptor
    GM758363Courtesy of GENERAL MOTORS CORP.
  2. Install the valve spring.
  3. Compress the valve spring.
  4. Install the valve spring keepers.
  5. Remove the air hose adaptor into the spark plug hole.
    6. Fig 3: View Of Valve Spring Compressor
    GM758361Courtesy of GENERAL MOTORS CORP.
  6. Remove the J 43649  from the cylinder head. See Special Tools .
  7. Install the spark plugs. Refer to Spark Plug Replacement in Engine Controls - 2.2L (L61).
    8. Fig 4: Identifying Camshaft Roller Followers
    GM758358Courtesy of GENERAL MOTORS CORP.
  8. Install the camshaft roller followers.
  9. Install the camshaft. Refer to Intake Camshaft and Lifter Replacement  or Exhaust Camshaft and Lifter Replacement .
scientia non olet · About LEMON Manuals