LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu Maxx >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Intake Camshaft and Lifter Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the camshaft cover. Refer to Camshaft Cover Replacement .
    2. Fig 1: View Of Upper Timing Chain Guide
    GM412167Courtesy of GENERAL MOTORS CORP.
  2. Remove the upper timing chain guide.
    3. Fig 2: View Of Camshaft Sprocket Holding Tool
    GM758310Courtesy of GENERAL MOTORS CORP.
  3. Install the J 43655  . See Special Tools .
    4. Fig 3: Removing/Installing Camshaft Timing Sprocket Retaining Bolts & Washers
    GM758314Courtesy of GENERAL MOTORS CORP.
  4. Remove both the intake and exhaust camshaft sprocket bolts and discard.
  5. Slide the camshaft sprockets forward.
    6. Fig 4: View Of Intake Camshaft And Caps
    GM412170Courtesy of GENERAL MOTORS CORP.
  6. Mark bearing caps to ensure they are installed in the original position.
    7. IMPORTANT: Remove each bolt on each cap one turn at a time until there is no spring tension on the camshaft.
  7. Remove the bearing caps.
  8. Remove the intake camshaft.
    9. Fig 5: View Of Camshaft Roller Followers
    GM412183Courtesy of GENERAL MOTORS CORP.
  9. Remove the camshaft roller followers.
    10. Fig 6: View Of Hydraulic Element Lash Adjusters
    GM412185Courtesy of GENERAL MOTORS CORP.
  10. Remove the hydraulic element lash adjusters.
scientia non olet · About LEMON Manuals