LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu Maxx >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Engine Mount To Body Bolts
    GM1229774Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount to the vehicle. Hand tighten the bolts at this time.
    2. Fig 2: Installing Engine Mount To Bracket Bolts
    GM1229782Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the engine mount to engine bracket bolts.

    Tighten: 

    • Tighten the engine mount to bracket bolts to 50 N.m (37 lb ft).
    • Tighten the engine mount to vehicle bolts to 50 N.m (37 lb ft).

  3. Remove the floor jack and block of wood.
  4. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls 2.2L (L61).
scientia non olet · About LEMON Manuals