LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu Maxx >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Intermediate Bracket To Engine Bolts
    GM1229780Courtesy of GENERAL MOTORS CORP.
  1. Install the intermediate bracket to the engine.
  2. Hand tighten the engine mount intermediate bracket bolts in the following locations:
    • The long bolts in the forward and front lower holes
    • The short bolt in the rear upper hole
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Tighten the intermediate bracket bolts.

    Tighten:  Tighten the bolts to 100 N.m (74 lb ft).

  4. Install the engine mount. Refer to Engine Mount Replacement .
scientia non olet · About LEMON Manuals