LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu Maxx >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Tensioner Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Drive Belt Tensioner
    GM758258Courtesy of GENERAL MOTORS CORP.
  1. Install the drive belt tensioner.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: In order to obtain the proper torque when using any torque wrench adapter you must use the following formula: Pre-set Torque = Torque Wrench Length x Torque Desired divided by Torque Wrench Length + Extension Length.
  2. Install the drive belt tensioner bolt.

    Use a J 45025 Torque Wrench Adapter  to tighten the drive belt tensioner bolt. See Special Tools .

    Tighten:  Tighten the drive belt tensioner bolt to 45 N.m (33 lb ft).

  3. Install the drive belt. Refer to Drive Belt Replacement .
scientia non olet · About LEMON Manuals