LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu Maxx >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Rear Oil Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Crankshaft Rear Oil Seal
    GM412495Courtesy of GENERAL MOTORS CORP.
  1. Use the J 42067  and install the seal. See Special Tools .
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 2: View Of Flywheel
    GM412119Courtesy of GENERAL MOTORS CORP.
  2. Install the flywheel.

    Tighten:  Tighten the flywheel bolts to 53 N.m (39 lb ft) plus 25 degrees.

  3. Install the transmission. Refer to Transmission Replacement in Automatic Transaxle - 4T40-E/4T45-E.
scientia non olet · About LEMON Manuals