Installation Procedure

WARNING: This page is about a different variant/trim than selected.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 1: View Of Camshaft Cover

Courtesy of GENERAL MOTORS CORP.

Install the camshaft cover and bolts.
Tighten: Tighten the camshaft cover bolts to 10 N.m (89 lb in).

Fig 2: View Of Camshaft Cover Ground Strap

Courtesy of GENERAL MOTORS CORP.

Install the ground strap to the camshaft cover.
Tighten: Tighten the ground strap stud to 10 N.m (89 lb in).

Fig 3: View Of Ignition Coil & Module Assembly

Courtesy of GENERAL MOTORS CORP.

Install the ignition coil and module assembly. Refer to Ignition Coil Housing Replacement in Engine Controls -2.2L (L61).
Install the fuel pipe bracket.
Tighten: Tighten the fuel pipe bracket bolt to 10 N.m (89 lb in).
Install the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement in Engine Controls -2.2L (L61).