Oil Pan Installation

WARNING: This page is about a different variant/trim than selected.

Fig 1: Applying RTV Around Perimeter Of Oil Pan & Oil Suction Port Opening

Courtesy of GENERAL MOTORS CORP.

Make sure that the oil pan and mounting surface on the lower crankcase are free of all oil and debris.
Apply a 2 mm bead of GM P/N 12346286 (Canadian P/N 10953472) or equivalent around the perimeter of the oil pan and the oil suction port opening.

Fig 2: Installing Oil Pan

Courtesy of GENERAL MOTORS CORP.

Fig 3: Identifying Oil Pan Bolts Removal & Tightening Sequence

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices

Install the oil pan bolts.
Tighten: Tighten the oil pan bolts to 25 N.m (18 lb ft) in sequence.