LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu Maxx >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Exhaust Camshaft, Follower, and Adjuster Removal

Exhaust Camshaft, Follower, and Adjuster Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Camshaft & Bearing Caps
    GM412191Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Remove each bolt on each cap one turn at a time until there is no spring tension pushing on the camshaft.
  1. Mark bearing caps to ensure they are installed in the same position.
  2. Remove the exhaust camshaft bearing cap bolts.
  3. Remove the camshaft bearing caps ensuring they are marked and refitted in same position on assembly.
  4. Remove the exhaust camshaft.
    5. Fig 2: Identifying Exhaust Camshaft Roller Followers
    GM412194Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Keep all of the roller finger followers and hydraulic element adjusters in order so that they can be reinstalled in their respective locations.
  5. Remove the exhaust camshaft roller finger followers.
    6. Fig 3: View Of Hydraulic Element Lash Adjusters
    GM412197Courtesy of GENERAL MOTORS CORP.
  6. Remove the hydraulic element adjusters.
scientia non olet · About LEMON Manuals