Engine Flywheel Installation
WARNING: This page is about a different variant/trim than selected.
Tools Required
- J 38122-A Harmonic Balancer Holder
- J 45059 Angle Meter. See Special Tools .
- Install the flywheel.
- Install the new bolts.
- Holding the crankshaft damper with the
J 38122-A
, tighten the bolts evenly.
Tighten: Using the J 45059 , tighten the bolts to 53 N.m (39 lb ft), plus 25 degrees using the J 45059 . See Special Tools .
NOTE:
Refer to Fastener Notice in Cautions and Notices.