LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu Maxx >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 2.2L (L61) - Introduction) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing & Installing Manifold Absolute Pressure Sensor
    GM897270Courtesy of GENERAL MOTORS CORP.
  1. Turn the ignition OFF.
  2. Remove the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
  3. Remove the throttle body. Refer to Throttle Body Assembly Replacement .
  4. Disconnect the manifold absolute pressure (MAP) sensor harness connector.
  5. Remove the MAP sensor and the MAP sensor port seal if it is still retained in the intake manifold
scientia non olet · About LEMON Manuals