LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu Maxx >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 2.2L (L61) - Introduction) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement (Malibu Sedan) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
    2. Fig 1: Removing FTP Sensor From Modular Fuel Sender (Malibu Sedan)
    GM1236104Courtesy of GENERAL MOTORS CORP.
  2. Relieve the system fuel pressure. Refer to Fuel Pressure Relief Procedure .
  3. Drain fuel tank. Refer to Fuel Tank Draining Procedure .
  4. Remove the fuel tank. Refer to Fuel Tank Replacement (Malibu Sedan) or Fuel Tank Replacement (Malibu MAXX) .
  5. Remove the electrical connector from the fuel tank pressure (FTP) sensor.
  6. Remove the FTP sensor from modular fuel sender.
scientia non olet · About LEMON Manuals