LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu Maxx >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 2.2L (L61) - Introduction) >> Repair Instructions >> Evaporative Emission (EVAP) Hoses/Pipes Replacement - Engine >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the air cleaner outlet duct assembly. Refer to Air Cleaner Outlet Resonator Replacement .
    2. Fig 1: Disconnecting Evaporative Emission (EVAP) Canister Purge Valve Harness Connector
    GM1238964Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the engine purge pipe from the evaporative emission (EVAP) canister purge valve.
  3. Remove the engine purge pipe.
scientia non olet · About LEMON Manuals