LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu Maxx >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 2.2L (L61) - Introduction) >> Repair Instructions >> Evaporative Emission (EVAP) Hoses/Pipes Replacement - Engine >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Evaporative Emission (EVAP) Hoses/Pipes
    GM783172Courtesy of GENERAL MOTORS CORP.
  1. Connect the engine purge pipe (3) to the evaporative emission (EVAP) canister purge valve (2).
  2. Install the air cleaner outlet duct assembly. Refer to Air Cleaner Outlet Resonator Replacement .
scientia non olet · About LEMON Manuals