LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu Maxx >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 2.2L (L61) - Introduction) >> Repair Instructions >> Evaporative Emission (EVAP) Hoses/Pipes Replacement - Engine/Chassis >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure .
  2. Remove the pipe retaining clip from the fuel feed pipe (1).
    3. Fig 1: Identifying Pipe Retaining Clip
    GM879147Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the fuel feed pipe from the engine fuel rail. Refer to Quick Connect Fitting(s) Service (Metal Collar) .
  4. Cap or plug the fuel pipe and the engine fuel rail to prevent contamination.
  5. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  6. Remove the rear brake pipe bracket retaining nuts and release the brackets from the body studs.
    7. Fig 2: View Of Fuel Hose/Pipe & Retainers At Vehicle Underbody
    GM49888Courtesy of GENERAL MOTORS CORP.
  7. Release the pipe retainers (1) from the vehicle underbody.
  8. Remove the fuel feed pipe from the pipe retainers.
  9. Lower the rear of the pipe while moving the pipe rearward slightly, then lower the front of the pipe.
  10. Remove the fuel feed pipe from the vehicle.
scientia non olet · About LEMON Manuals