LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu Maxx >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 2.2L (L61) - Introduction) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement (Malibu Sedan) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing EVAP Canister Vent Valve (Malibu Sedan)
    GM1236107Courtesy of GENERAL MOTORS CORP.
  1. Slide the new EVAP canister vent valve onto the mounting foot on the fuel tank.
  2. Slide the valve forward until it snaps into place on the mounting foot.
  3. Connect the hose to the EVAP canister vent valve.
  4. Connect the EVAP vent valve harness connector.
  5. Raise the fuel tank back into position and install the fasteners. Refer to Fuel Tank Replacement (Malibu Sedan) .
  6. Reconnect the fuel fill pipe at the fuel tank and connect the vapor line on the fuel fill pipe.
scientia non olet · About LEMON Manuals