LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu Maxx >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 2.2L (L61) - Introduction) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Replacement (Malibu Sedan) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the fuel tank from the vehicle. Refer to Fuel Tank Replacement (Malibu Sedan) .
  3. Disconnect the EVAP canister vent valve hose.
  4. Disconnect the vapor line from the fuel tank to the EVAP canister.
  5. Disconnect the purge line from the EVAP canister.
    6. Fig 1: Removing Screw In EVAP Canister Mounting Pad (Malibu Sedan)
    GM1236120Courtesy of GENERAL MOTORS CORP.
  6. Remove the screw in the EVAP canister mounting pad on the fuel tank and slide the EVAP canister upward off of the mount.
scientia non olet · About LEMON Manuals