LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu Maxx >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 2.2L (L61) - Introduction) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the EVAP canister purge valve on to the purge bracket.
    2. Fig 1: View Of EVAP Canister Purge Valve
    GM857194Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the EVAP canister purge valve and bracket.

    Tighten:  Tighten the purge bracket nut to 8 N.m (71 lb in).

    3. Fig 2: Disconnecting Evaporative Emission (EVAP) Canister Purge Valve Harness Connector
    GM1238964Courtesy of GENERAL MOTORS CORP.
  3. Connect the purge pipe to the EVAP canister purge valve.
  4. Connect the vacuum pipe to the EVAP canister purge valve.
  5. Connect the EVAP canister purge valve harness connector.
scientia non olet · About LEMON Manuals