LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu Maxx >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 2.2L (L61) - Introduction) >> Repair Instructions >> Engine Coolant Temperature (ECT) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing & Installing Engine Coolant Temperature Sensor
    GM895897Courtesy of GENERAL MOTORS CORP.
  1. Turn the ignition OFF.
    2. IMPORTANT: Engine coolant must be drained below the level of the engine coolant temperature (ECT) sensor.
  2. Disconnect the ECT sensor harness connector.
  3. Remove the ECT (1).
scientia non olet · About LEMON Manuals