LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 707 (Automatic Transaxle - 4T80-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Vehicle Speed Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: View Of Mounting Bolt Locations
    GM588753Courtesy of GENERAL MOTORS CORP.
  2. Remove the bolts (1, 3) securing the front transaxle brace (2) to the transaxle and right cylinder head.
  3. Remove the electrical connector at the vehicle speed sensor.
    4. Fig 2: Identifying Sensor & Retaining Bolt
    GM11835Courtesy of GENERAL MOTORS CORP.
  4. Remove the retaining bolt (131) and the sensor (130). Twisting the sensor while pulling outward will aid in removal.
scientia non olet · About LEMON Manuals