Installation Procedure

WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to Fastener Notice .

Fig 1: Identifying Sensor & Retaining Bolt

Courtesy of GENERAL MOTORS CORP.

Install the vehicle speed sensor (130) and the retaining bolt (131). Install a new O-ring seal on sensor if necessary.
Tighten: Tighten the bolt to 10 N.m (89 lb in).
Install the electrical connector at the sensor.

Fig 2: View Of Mounting Bolt Locations

Courtesy of GENERAL MOTORS CORP.

Install the bolts (1, 3) securing the front transaxle brace (2) to the transaxle and right cylinder head.
Lower the vehicle.