Installation Procedure

WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to Fastener Notice .

Fig 1: View Of Torque Converter Cover

Courtesy of GENERAL MOTORS CORP.

Install the torque converter cover.
Tighten: Tighten the cover bolt to 12 N.m (106 lb in).
Install the engine-to-transmission brace and attaching bolts.
Tighten: Tighten the bolts to 47 N.m (35 lb ft).
Lower the vehicle.