LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 707 (Automatic Transaxle - 4T80-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Final Drive Internal Gear Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the final drive carrier. Refer to Final Drive Assembly Replacement .
  3. Fig 1: Identifying Final Drive Internal Gear & Snap Ring
    GM687607Courtesy of GENERAL MOTORS CORP.
  4. Remove the final drive internal gear snap ring (135).
  5. Remove the final drive internal gear (120).